Chapter 2. Hardware Interface; Physical Descriptions; Identification Of Ica-E5550V Connectors; I/O Control Instruction - Planet Networking & Communication ICA-E5550V User Manual

Chapter 2. Hardware Interface

2.1 Physical Descriptions

2.1.1 Identification of ICA-E5550V connectors

1. Memory Card Slot: Support microSDHC and microSDXC cards.
Insert a memory card (not included) into this slot for local recording purposes.
2. Reset Button: Use the Reset Button to reset the camera to its factory default settings. To
do the reset, press and hold the Reset button for at least 5 seconds or until the Power LED
lights up. When the Power LED lights up again, reset is complete.
3. DI/DO
Depending on your surveillance needs, you may connect digital input / output or audio input /
output devices to your camera. The camera comes with one terminal block for both digital and
audio input/output devices..
4. Ethernet Port
Connect to a network using a standard Ethernet cable.

2.1.2 I/O Control Instruction

1) Identification
Device
Digital Output (DO)
Digital Input (DI)
1 2 3 4
Pin Mapping Instructions
1 DIO PW Connect the wires of the output device to DIO PW
(Pin 1) and DO (Pin 3).
3 DO
2 DIO GND Connect the wires of the input device to DIO GND
(Pin 2) and DI (Pin 4).
4 DI
13
5 Mega-pixel Vandalproof IR PoE IP Camera
For Audio Use
ICA-E5550V