Hardware Installation; Physical Installation - Planet Networking & Communication ICA-HM135 User Manual

H.264 mega-pixel 20m ir vandal proof dome ip camera

Table of Contents

2.3 Hardware Installation

1. Fix Internet camera to desired location with mount fixture

2. Connect RS-485 D+ and D- (if you need to control PT scanner)

3. Connect an Ethernet cable

Connect the LAN cable on the camera to the network device (hub or switch).

NOTE:

If there has an IEEE802.3af PoE switch in your network, you can connect the

camera LAN cable to this PoE switch to obtain power. The power adapter is

unnecessary when internet camera is connected to a PoE switch.

4. Check the LAN LED

The LED is defined to identify LAN connection type. When LAN port is connected, the LED

will be green.

5. Attach the power supply

Plug in power adapter and connect to power source. After power on, the camera will start to

operate.

NOTE:

1. Only use the power adapter supplied with internet camera Otherwise, the

product may be damaged.

2. The power adapter is unnecessary when internet camera is connected to a

PoE switch. Otherwise, the product may be damaged when internet camera is

connected to a PoE switch and power adapter simultaneously.

6. Attach BNC connector (option)

Connect the video BNC connector to a monitor set if necessary check camera viewing angle

and focus.

5 Attach Speaker to camera (option)

If user needs not only video stream but also audio stream, then the speaker should be

attached to camera.

Table of Contents