Replacing the Filter (Filter is optional.)
The interval of the filter replacement is affected by the dustiness. Check the filters periodically for better
performance.
Note:
Dirty filter may reduce the air flowing into the projector and the temperature in the projector may rise
as the result. This may activate the protection mechanism or damage the components.
Important:
Check, clean, and replace the filter periodically.
Perform the following to replace the filter:
1.
Turn the projector off. Allow the projector to cool down into standby mode.
2.
Push the filter cover downwards to remove it.
3.
Remove the filter from its compartment as shown
in the illustration.
4.
Install the new filter by reversing the previous steps.
DLP Projector — Owner's Manual
57
—
—