Left View - Eiki EK-800U Owner's Manual

Left View

I L
tem abeL
1 3D Sync OUT
2 DVI-D
3 VGA IN
4 VGA OUT
5 Component/
RGBHV IN
6 Built-in Keypad
7 Remote OUT
8 Remote IN
9 Kensington Lock
10 HDBaseT
11 Ethernet
12 Service
13 USB
14 HDMI
15 3G-SDI IN
16 Video IN
17 RS-232C
18 AC Input
Note:
• To use this feature, you must plug in the connector before turn on/off the projector.
• Do not use this jack for anything other than intended use.
Warning:
As a safety precaution, disconnect all power to the projector and connecting devices before making
connections.
1 2 3 4
18 17 16 15 14 13 12
Connect the 3D IR glasses transmitter
(Note: For Specific 3D IR glasses only)
Connect to DVI source.
Connect the VGA cable from a computer or component device.
Connect the VGA cable to a display.
Connect to RGB or YPbPr/YCbCr output signal with BNC type
input terminal.
Control the projector.
Connect to a second projector when the system uses multiple
projectors.
Connect to the remote control wired terminal for serial control
projector.
Use to secure the projector to countertops, tables, etc.
Connect a RJ45 Cat5/Cat6 Ethernet cable to input
uncompressed high-definition video control signals.
Connect a LAN cable from Ethernet.
Service only.
Connect the WIFI dongle.
Connect the HDMI cable from a HDMI device.
Connect the coaxial cable with BNC connector from a 3G-SDI
device.
Connect the COMPOSITE cable from a video device.
Connect RS-232 serial port cable for remote control.
Connect to the supplied power adapter.
—
DLP Projector — Owner's Manual
5 6
11 10 9 8 7
D
escrIptIon
3
—
s
ee page
-
-
-
-
-
4
-
-
61
-
-
-
-
-
-
-
-
10