Table of Contents
Advertisement
Maintenance Of Projector
Maintenance of Projector
Filter
Sponge Filter
When a warning message appears to remind you to clean the sponge filter, please clean
the sponge filter immediately. (P.32)
<Please check and clean the air filter periodically.>
Replacing the Anti-dust filter (Part Numcer:13340230)
When the use time reaches the filter counter time, the projector will display a message to
remind replacing a new filter. If there is no spare air filter available, please contact your
dealer.
When the use time reaches the filter counter time, the projector will display a message
to remind replacing a new Anti-dust filter. If there is no spare Anti-dust filter available,
please contact your dealer.
Turn off the projector, and unplug the power cord. Allow the projector to sufficiently
cool down.
1. Remove the filter cover from the side of projector.
2. P ull out the Anti-dust filter and pack the filter in plastic bag before disposing it.
3. I t is recommended that you clean dust on the filter cover by vacuum cleaner, then
gently brush the other side of the filter cover by brush.(Please do not clean the sponge
filter with water.)
4. I nstall Anti-dust filter and press the filter until it is tightly loaded into the filter case.
5. C lose the filter cover. When installing, make sure the two extruded points on the filter
are facing downward.
6. After installing Anti-dust filter, reset the filter timer.(P.30)
Notice:
When upper right corner of the image appears warning message as the graphic shows,
it indicates there is a problem with the installation of the Anti-dust filter. Please check
again if the Anti-dust filter is firmly installed.
1. Please check if Anti-dust filter is installed or not?
2. Please check if the filter cover is properly closed or not?
1
Filter cover
3
Anti-dust filter
2
Sponge filter
3
47
Advertisement
Table of Contents
