DLP Projector — Owner's Manual
Replacing the Projection Lens
Perform the following to replace the projection lens:
1.
Center the lens. Use the Lens H or Lens V button (on the remote control) to adjust the lens at its center
position.
Important:
• Ensure that the lens is at or near its center position.
• Attempting to remove the lens when at a large offset may cause damage to the lens assembly.
2.
Turn the projector off. Allow the projector to cool down into standby mode.
3.
Press and hold the Lens Release button, and then rotate
the lens counter-clockwise to release the lock.
4.
Remove the lens out of the lens mount.
5.
Install the new lens. See "Installing the Projection Lens" on page 10.
56
—
—