Light Source Settings Menu - Eiki EK-800U Owner's Manual

Light Source Settings Menu

Press the Menu button to open the OSD menu. Press the arrow keys (pq) to select OPTION and press
the Enter button to enter the OPTION menu. Press the arrow keys (pq) to select Light Source Settings
and press the Enter button to enter the Light Source Settings menu. Press the arrow keys (pq) to
select the menu option and press the Enter button to enter its submenu. Press the arrow keys (pqtu)
to select or adjust the desired settings and press the Enter button to confirm.
I
tem
Light Source Mode
Constant Power Settings
Constant Luminance
Settings
Current Light Source
Auto Switch
Auto Switch Time (Hours)
Light Source Info
Reset Light Source Hours
PICTURE
Light Source Mode
Constant Power Settings
Constant Luminance Settings
OUTPUT
Current Light Source
Auto Switch
Auto Switch Time (Hours)
SETUP
Light Source Info
Reset Light Source Hours
OPTION
Select Constant Power, Constant Luminance, or Eco Mode. When in
Eco Mode, the projector will adjust to the lowest fan speed and switch the
light source power to the minimum setting.
Set the value of the light source power (in Watts).
Set the value for the Constant Luminance to maintain constant brightness.
The light sensor will monitor the light level and will apply more power as the
light source brightness decays naturally over time. When the light source
setting reaches maximum power, it will remain at this setting. Note that the
light sensor needs to be calibrated for Constant Luminance mode to work
properly.
Select which lamp(s) is in use.
Control when the projector switches lamps. Options include: on failure only,
at power-up, or after a set number of hours.
Set the number of hours for Lamp Auto Switch.
For example:
1 Lamp conditions: lamp 1 = 50 hours, lamp 2 = 60 hours.
2 Set the current lamp to lamp 1 - the lamp with the lower lamp hour usage.
3 Set the Lamp Auto Switch to After (N) hours and the Lamp Auto Switch
Time to 100 hours.
4 When lamp 1 reaches 150 hours, projector will auto switch to lamp 2.
5 When lamp 2 reaches 160 hours, projector will auto switch to lamp 1.
Display current lamp(s) settings (read-only).
Reset the lamp used hours counter to zero. Do this after changing the
lamp.
DLP Projector — Owner's Manual
Light Source Settings
D
escrIptIon
43
— —
Constant Power
10
0
Both
On Failure Only
100