Replacing The Filter Cartridge - Eiki EIP-HDT30 Service Manual

Maintenance

Replacing the Filter Cartridge

1
Turn off the projector, press the Main On/Off Switch to
Off and unplug the AC power cord from the AC outlet.
2
First, clean up the dust on the projector and around the
air vents.
3
Open the filter cover. (See the right figure.)
4
Pull out the filter cartridge. When taking out the filter
cartridge, put your finger on the filter cartridge's tab and
then pull.
5
Put the new one back into the position and close the filter
cover. Make sure that the filter cartridge is properly and
fully inserted.
6
Connect the AC power cord to the projector and turn on
the projector.
Reset the filter counter and the scroll counter.
7
cautIoN
- Do not put anything into the air vents. Doing so
may result in malfunction of the projector.
- In the event of installation/replacement of the fil-
ter cartridge, turn off the projector, press the Main
On/Off Switch to Off and unplug the AC power
cord from the AC outlet.
recoMMeNdatIoN
We recommend avoiding dusty/smoky environments when
operating the projector. usage in these environments may
cause a poor image quality.
When using the projector under dusty or smoky conditions, dust
may accumulate on a lens, or optical elements inside the projector.
Such condition may degrade the quality of the projected image.
When the symptoms above are noticed, contact your authorized
dealer or service station for proper cleaning.
ORDER REPLACEMENT FILTER CARTRIDGE
Service Parts No. : 610 350 7811
Filter cover
Filter cartridge
-10-
Tab