Table of Contents
Advertisement
2-5 Boot Installation
To mount the boot plate P#(B0079) to the boot
P#(E1030), use (2) 3/8"-16 x 1" carriage bolts P#(K1182)
and (2) 3/8"-16 flange nuts P#(K1215). Make certain that
when bolting the boot and boot plate together, that the
head of the bolt is placed from the inside of the boot.
This will prevent grass from collecting on the bolts. Hang
the boot onto the mower deck, use Figure 2-5 for details.
There are slots in the boot plate that will allow for
adjustment to the left or right to achieve the proper fit for
different size cutting decks. Once the boot is in place,
tighten the bolts on the mower deck's deflector shield,
and rotate the deflector against the boot. The deflector
will help keep the boot from moving.
Figure 2-5
Boot
NOTE: 2007 MODELS ONLY
Mount the boot plate P#(B0435) to the boot P#(E1031)
using (2) 3/8"-16 x 1" carriage bolts P#(K1182) and (2)
3/8"-16 flange nuts P#(K1215). Mount the boot plate to
the mower deck using the boot rod P#(B0288) and
fasten with (1) hair pin clip P#(K0099). See Figure 2-5b.
Figure 2-5b
Hair Pin Clip
Figure 2-7
Boot Plate
(1) 5/32" x 2-5/8" Hair Pin Clip
Boot Rod
Boot Plate
10 7
2-6 Upper Frame Assembly
Installation
NOTE: During this step, it is suggested that two people
install the upper frame to the lower mount tube.
Using two people to lift the upper frame, lift the upper
frame above the lower mount assembly P#(A0672)
making sure the frame is pointing away from the mower
(Figure 2-6). Slide the upper frame tube into the lower
mount assembly aligning the mounting hole. Insert (1)
½" x 2-1/2" clevis pin P#(K0133) through the hole and
fasten with (1) 5/32" x 2-5/8" hair pin clip P#(K0088).
(1) ½" x 2-1/2" Clevis Pin
2-7 Top Assembly To Upper Frame
Assembly Installation
Align the pivot brackets of the top assembly P#(A0551)
to the pivot point on either side of the upper frame
assembly. Place (1) P#(K0041) fender washer between
each pivot point (Figure 2-7) and fasten each side by
using (1) P#(K1153) 5/16"-18 x 3/4" HHCS and (1)
P#(K1180) 5/16"-18 nyloc nut. When fastening leave nut
slightly loose so that the top can pivot freely.
Top Assembly Here
Figure 2-7
Upper Frame
Assembly
Lower Mount Assembly
(1) 5/16"-18 x 3/4" HHCS
(1) 5/16"-18 Nyloc Nut
(1) Fender Washer
Per Side
Advertisement
Table of Contents
