Table of Contents
Advertisement
2-2 Lower Frame Leg Installation
Remove the (3) bolts (Figure 2-2a) from each side of the
rear of the mower. Keep the bolt, from each side, that
threads through the mower's rear frame. Place the left
lower main frame leg assembly P#(A0511) onto the rear
of the mower and fasten by using (2) 3/8"-16 x 3" HHCS
P#(K1198) and (2) 3/8"-16 flange nuts P#(K1215). Use
the existing bolt removed from the mower to fasten the
front side of the leg. Repeat this step to fasten the PTO
mount plate assembly P#(A0630).
Figure 2-2a.
Existing Bolt
Safety Interlock Harness Connection
The safety interlock harness is located inside of the
PTO assembly (Figure 2-2b). To install the harness to
the mower, lift the hood of the mower for engine
compartment access. Route the harness toward the
parking brake switch bracket on the mower. Fasten the
harness to the mower's rear frame by using (1) zip tie
P#(J0245) to prevent the harness from rubbing the
mower's tire. Next, carefully cut away the harness
covering from the parking brake switch harness to
access the wiring, taking care not to damage the wiring
inside (Figure 2-2c). Select one of the brown/yellow
wires from the parking brake switch harness, cut and
strip both ends of the wire. Crimp on the (2) push on wire
connectors provided, (1) male P#(P0099) and (1) female
P#(P0106). See figure 2-2d for more detail. When
finished, connect the (2) wire connectors P#(P0099) and
P#(P0106) to the end of the safety interlock harness.
(2) 3/8" x 3" HHCS
Left Lower
Switch Harness
Main Frame Assembly
6
Figure 2-2b
Free End Of
Harness For
Routing
Figure 2-2c
Parking Brake
Cut Wire
Harness
Connected
Here
Safety Interlock
Harness
Crimped Push
On Connectors
Advertisement
Table of Contents
