System Check - Jøtul GF 370 DV II Installation And Operation Instructions Manual

10. Initial System Check
The burner and fan control system consists of the
following built-in or supplied components:
1) Remote Transmitter - 3, AAA batteries preinstalled
2) Remote Receiver - 4, AA backup batteries preinstalled
3) Fan Control Module - switched
All internal connections have been made at the
factory. The remote controls are preprogramed and
the entire system tested.
NOTE: Check the build date on the shipping
crate label. If it has been more than 6 months
since the build date, be prepared to replace
the Receiver and Transmitter batteries.
Follow this procedure for the initial system check
following installation:
1. Connect the power extension cord to the interior
power cord and to a 120V electrical outlet.
2. PURGING THE GAS LINE: Open the gas supply
valve. When lighting the appliance for the first
time it will take a few moments to clear the gas
line of air. Once the purge is complete, the pilot
light will be able to ignite.
PILOT MODE
CPI
Proflame 2
Remote
ON
Figure 32. Correct Pilot flame pattern.
IPI
BURNER
T-STAT
OFF
3. Set the Pilot Mode:
• CPI for continuous pilot operation or Proflame 2
Remote functionality.
• IPI for intermittent operation.
4. Once the pilot is lit, burner operation is controlled
by the rocker switch located on the front panel. See
fig. 32.
ON / OFF - use for manual control of the burner.
It remains in the ON position for use with the
Proflame 2 remote transmitter.
T-STAT - use for optional wall thermostat.
5. PILOT FLAME: The pilot flame should be steady
-not lifting or floating. The flame should be blue in
color around the pilot hood, with traces of yellow
toward the outer edges. It is important that the
pilot flame engulf the top 1/8" of the flame sensor.
The pilot flame should project out of the pilot
hood 1" from both ports extending to reach the
burner plate ports. See fig. 36. The pilot flame can
be tuned by turning the adjustment screw located
on the front of the valve. See fig. 20.
6. INSTALLER PLEASE NOTE:
CHECK FUNCTIONALITY. The burner, remote
control and fan functions have each been tested at
the factory. However, it is important to run through
each function and be sure to familiarize the
homeowner with the operation procedures. See
the Operation section on pages 24-27 for details
regarding Remote Control functions and settings.
Ignitor
Flame
Sensor
Figure 36. Correct Pilot flame pattern.
139467_03 GF 370 DV II June 2015
Carry-over Ports
21