Jøtul GF 370 DV II Installation And Operation Instructions Manual page 26

139467_03 GF 370 DV II June 2015
SMART Thermostat Function
This function adjusts the flame intensity according to
the difference in the Set Point temperature and the
actual room temperature. As the room temperature
gets closer to the Set Point, the Smart Function will
modulate flame intensity down.
To activate this function, press the Thermostat Key

until the woed "SMART" appears to the right of the
thermometer bulb icon. Fig. 50.
To adjust the temperature, press the Up or Down

Arrow Keys until the desired Set Temperature is
displayed. Fig. 51.
Fan Speed Control
Fan speed can be adjusted through six settings. To

activate this function, press the Mode Key (Fig. 40)
to index to the Fan Control icon. See fig. 52.
Use the Up/Down Arrow Keys to turn ON, OFF, or

adjust the fan speed. Fig. 53. A single "beep" will
confirm reception of the command.
Accent Lamp Control ( Auxiliary 120V Outlet)
The auxiliary function controls the Accent Lamp

power. Press the Mode Key to index to the AUX
icon. Figs. 54-55.
Pressing the Up Arrow Key will turn the Lamp ON.

Lamp brightness can be adjusted by turning the
dimmer knob on the stove Control Panel.
Pressing the Down Arrow Key will turn the Lamp OFF.

Child Safety Lock
This function will lockout the Transmitter to prevent
unsupervised operation.
To activate the Lock, press the Mode key and UP Key

at the same time. Fig. 56.
To de-activate the Lock, press the Mode Key and UP

Key at the same time.
Low Battery Detection
The life-span of the batteries depends on various
factors; battery quality, the frequency of ignition calls,
the frequency of changes to Set Points, etc.
When Transmitter batteries are low, the Battery

icon will be displayed before all battery power is
lost. The icon will disappear when new batteries
are installed.
When Receiver batteries are low, no "beep" will

be emitted from the Receiver when it receives an
On/Off command from the Transmitter. This is an
alert for a low battery condition in the Receiver.
When the batteries are replaced, the "beep" will
26
Figure 50. Smart Mode
Figure 52. Fan Mode
Figure 54. Lamp Control
Figure 56. Lock ON
be emitted from the Receiver when the ON/OFF
Key is pressed. See Battery Replacement under the
Maintenance section of this manual.
Manual By-Pass of the Remote System
When battery power is low or depleted, the burner
can still be operated manually by sliding the Receiver
switch to the ON position. It will immediately ignite
in the High position.
In the event of a power failure, flame modulation,
themostatic control, fan and lamp functions will be
unavailable. It is therefore aDV IIisable to keep a sup-
ply of good quality batteries on hand.
Figure 51. Smart Set Temp.
Figure 53. Fan Speed
Figure 55.. Lamp ON
Figure 57. Low Battery