System Menu; Arc Hours; Arc Starts; User Interface Software Version - Miller Electric Millermatic 350P Aluminum Owner's Manual

6-14. System Menu

6-14-1.

Arc Hours

This menu reports the arc time in hours. "HRS" "XX.X"
6-14-2.

Arc Starts

This menu reports the number of arc starts. "ARCS" "XXXX"
6-14-3.

User Interface Software Version

This menu reports the software version of the User Interface Board. "IXXX" "XXXX"
6-14-4.

Control Software Version

This menu reports the software version of the Control Board. "CXXX" "XXXX"
6-14-5.

Gun Calibration

This menu allows the user to run gun calibration. See Section 6-15 for more information. "G.CAL" "XXXX"
6-14-6.

Hot Start Enable (Pulse only)

This menu allows the user to enable the hot start feature. Hot start can be turned on ("ON"), turned off ("OFF"), or turned to automatic settings
("AUTO"). The automatic settings are the preset factory recommended parameters. For more detailed information on Hot Start see Section 6-17.
6-14-7.

Crater Fill Enable

This menu allows the user to enable and disable the crater fill feature. For more information see Section 6-18.
6-14-8.

Trigger Schedule Select

This menu allows the user to enable and disable the dual schedule feature. For more information see Section 6-16.
OM-254915 Page 46
.
A complete Parts List is available at www.MillerWelds.com
1
1 Lit Indicators
To access the system menu press
both the setup button and the Arc
Control button at the same time.
Once on the system menu the left
1
adjustment knob scrolls through
the options.
Ref. 242 929-C