IDEAL COMBI ESP 24 Pocket Manual page 20

20
OPERATIONS MODE.
DISPLAY CODE
ON THE BOILER
FAULT CODES.
DISPLAY CODE ON THE BOILER
DESCRIPTION
The boiler is in standby mode awaiting either a central heating call or hot water
demand.
The boiler has a call for central heating but the appliance has reached the desired
temperature set on the boiler.
The boiler has a call for hot water but the appliance has reached the desired
temperature set on the boiler.
The boiler is operating in central heating mode.
The boiler is operating in hot water mode.
The boiler is operating in frost mode.
DESCRIPTION ACTION
Outside sensor Reset the appliance - if the boiler fails to operate then please
failure
contact Ideal(if under warranty) or alternatively a Gas Safe
Registered Engineer if outside of the warranty period. In IE
contact a Registered Gas Installer (RGII).
Low mains voltage Contact a qualified electrician or your electricity provider.
Unconfigured PCB Unconfigured PCB. Please contact Ideal(if under warranty) or
alternatively a Gas Safe Registered Engineer if outside of the
warranty period. In IE contact a Registered Gas Installer (RGII).
No water flow Reset the appliance - if the boiler fails to operate then please
thermistor
contact Ideal (if under warranty) or alternatively a Gas Safe
Registered Engineer if outside of the warranty period.
In IE contact a Registered Gas Installer (RGII).