IDEAL independent 15 User Manual

Hide thumbs Also See for independent 15:

Advertisement

USERS
INDEPENDENT systeM
15 18 24 30
For Installation Guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
For the very latest copy of literature for specification and maintenance practices visit our
website www.idealboilers.com where you can download the relevant information in PDF format.

Advertisement

Table of Contents
loading

Summary of Contents for IDEAL independent 15

  • Page 1 Do not use reconditioned or copy parts that have not been clearly authorised by Ideal. For the very latest copy of literature for specification and maintenance practices visit our...
  • Page 2: Electricity Supply

    Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal stelrad group is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency.
  • Page 3: Operation

    Frost protection Operation If no system frost protection is provided and frost is likely during a note. The pump will operate briefly as a self-check once every 24 short absence from home, leave the heating controls (if fitted) at a hours, regardless of system demand.
  • Page 4: Condensate Drain

    Condensate Drain Escape of gas Should a gas leak or fault be suspected contact the National Gas This appliance is fitted with a siphonic condensate trap Emergency Service without delay. Telephone 0800 111 999 system that reduces the risk of the appliance condensate from freezing.
  • Page 5: Points For The Boiler User

    pOINTs FOR ThE BOILER UsER Note. In line with our current warranty policy we would ask that you check through the following guide to identify any problems external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other than with the appliance we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is not gained by the engineer.
  • Page 6: Operation Modes

    OpERaTION MODEs DEsCRIpTION DIspLay CODE ON BOILER The boiler is in standby mode awaiting either a central heating call or hot water demand. The boiler has a call for central heating / hot water but the appliance has reached the desired temperature set on the boiler.
  • Page 7: Fault Codes

    5 Boiler Resets in 15 minutes 1. Turn power off and on at the fused spur. 2. If the boiler fails to operate please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the warranty period.
  • Page 8 Ideal stelrad group pursues a policy of continuing improvement in the design and performance Ideal Consumer Helpline of its products. The right is therefore reserved to vary specification without notice. Tel: 01482 498660 Ideal, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN.

This manual is also suitable for:

Independent 18Independent 24Independent 30

Table of Contents