248
4-3. Operating the lights and wipers
Turning the high beam on/off manually
■
Switching to low beam
Pull the lever to the original
position.
The Automatic High Beam indi-
cator will turn off.
Push the lever away from you to
activate the Automatic High
Beam system again.
■
Switching to high beam
Press
the
Beam switch.
The Automatic High Beam indi-
cator will turn off and the high
beam indicator will turn on.
Press the switch to activate the
Automatic High Beam system
again.
■
The Automatic High Beam can be operated when
The engine switch is in IGNITION ON mode.
■
Camera sensor detection information
●
High beam may not be automatically turned off in the following situations:
• When oncoming vehicles suddenly appear from a curve
• When the vehicle is cut in front of by another vehicle
• When oncoming or preceding vehicles are hidden from sight due to
repeated curves, road dividers or roadside trees
●
High beam may be turned off if an oncoming vehicle that is using fog lights
without using the headlights is detected.
●
House lights, street lights, red traffic signals, and illuminated billboards or
signs may cause the high beam to turn off.
HIGHLANDER_U (OM48E98U)
Automatic
High
I n f o r ma t i o n P r o v i d e d b y :