Toyota highlander 2015 Instruction Manual page 301

Hide thumbs Also See for highlander 2015:
Table of Contents

Advertisement

Turning off both TRAC and VSC systems
To turn the TRAC and VSC systems off, press and hold
seconds while the vehicle is stopped.
The VSC OFF indicator light will come on and the "TRAC OFF" will be shown
on the multi-information display.
Press
again to turn the systems back on.
*
: On vehicles with pre-collision system, pre-collision brake assist and pre-
collision braking will also be disabled. The pre-collision system warning
light will come on and the message will be shown on the multi-information
display. (P. 306)
When the message is displayed on the multi-information display show-
ing that TRAC has been disabled even if
pressed
TRAC, hill-start assist control and downhill assist control cannot be operated.
Contact your Toyota dealer.
Sounds and vibrations caused by the ABS, brake assist, TRAC, VSC and
hill-start assist control systems
A sound may be heard from the engine compartment when the brake pedal
is depressed repeatedly, when the engine is started or just after the vehicle
begins to move. This sound does not indicate that a malfunction has
occurred in any of these systems.
Any of the following conditions may occur when the above systems are
operating. None of these indicates that a malfunction has occurred.
• Vibrations may be felt through the vehicle body and steering.
• A motor sound may be heard after the vehicle comes to a stop.
• The brake pedal may pulsate slightly after the ABS is activated.
• The brake pedal may move down slightly after the ABS is activated.
EPS operation sound
When the steering wheel is operated, a motor sound (whirring sound) may be
heard. This does not indicate a malfunction.
Automatic reactivation of TRAC and VSC systems
After turning the TRAC and VSC systems off, the systems will be automati-
cally re-enabled in the following situations:
Vehicles without a smart key system: When the engine switch is turned to
the "LOCK" position
Vehicles with a smart key system: When the engine switch is turned off
If only the TRAC system is turned off, the TRAC will turn on when vehicle
speed increases
If both the TRAC and VSC systems are turned off, automatic re-enabling will
not occur when vehicle speed increases.
HIGHLANDER_U (OM48E98U)
4-5. Using the driving support systems
*
switch has not been
I n f o r ma t i o n P r o v i d e d b y :
301
for more than 3
4

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

2014 highlander

Table of Contents