Toyota highlander 2015 Instruction Manual page 274

274
4-5. Using the driving support systems
■
Dynamic radar cruise control can be set when
●
The shift lever is in the D or range 4 or higher of S has been selected.
●
Vehicle speed is above approximately 30 mph (50 km/h).
■
Accelerating after setting the vehicle speed
The vehicle can accelerate normally. After acceleration, the set speed
resumes. However, during vehicle-to-vehicle distance control mode, the vehi-
cle speed may decrease below the set speed in order to maintain the dis-
tance to the vehicle ahead.
■
Automatic cancelation of vehicle-to-vehicle distance control
Vehicle-to-vehicle distance control driving is automatically canceled in the fol-
lowing situations:
●
Actual vehicle speed falls below approximately 25 mph (40 km/h).
●
Enhanced VSC is activated.
●
VSC is activated.
●
The sensor cannot operate correctly because it is covered in some way.
●
The windshield wipers are operating at high speed (when the wiper switch is
set to the high speed wiper operation position).
If vehicle-to-vehicle distance control driving is automatically canceled for any
other reason, there may be a malfunction in the system. Contact your Toyota
dealer.
■
Automatic cancelation of constant speed control
The cruise control will stop maintaining the vehicle speed in the following situ-
ations:
●
Actual vehicle speed is more than approximately 10 mph (16 km/h) below
the set vehicle speed.
At this time, the memorized set speed is not retained.
●
Vehicle speed falls below approximately 25 mph (40 km/h).
●
Enhanced VSC is activated.
●
VSC is activated.
HIGHLANDER_U (OM48E98U)
I n f o r ma t i o n P r o v i d e d b y :