Philio Z-Wave PHI PSM02 Quick Start Manual page 6

Operation Mode (Parameter Number 5, Parameter Size 1) parameter to set the Operation Mode
Value
Bit 0: 1 means security mode; 0 means home automation mode. Bit 1: 1 means enable test
mode; 0 means disable test mode. Notice: Bit0 and Bit1 will effect when the DIP Switch setting
0 —
to program mode. If Bit1 is enabled, the Bit0 is useless. Bit 2: Disable the door/window function.
127
Bit 3: Setting the temperature scale. 0: Fahrenheit, 1:Celsius Bit 4: Disable illumination report
after event triggered. Bit 5: Disable temperature report after event triggered (Default 0)
Multi-Sensor Function Switch (Parameter Number 6, Parameter Size 1) parameter to set the sensor
functions
Value
Bit 0: Disable magnetic integrate illumination. Bit 1: Disable PIR integrate Illumination. Bit 2:
Disable magnetic integrate PIR (Default is Disable) Bit 3: When Bit2 is 0 (Enable), the device is
install in the same room with the light? 0: In the same room(Default), 1: In the different room. Bit
0 — 4: Disable delay 5 seconds to turn off the light, when door/window closed. Bit 5: Disable auto turn
127 off the light, after door/window opened to turn on the light. Notice: If bit2 is zero, this setting is
useless. Bit 6:Enable temperature monitoring. When this bit enable, the temperature changed 3
degree Fahrenheit, it will report. And also the temperature over 140 degree Fahrenheit, it will
report every 64 seconds. (Default 4)
PIR Re-Detect Interval Time (Parameter Number 8, Parameter Size 1) In the security mode, after the PIR
motion detected, setting the re-detect time
Value
3 — 127 8 seconds per tick, and minimum time is 24 seconds, default tick is 3 (24 seconds). (Default 3)
Turn Off Light Time (Parameter Number 9, Parameter Size 1) After turn on the light, setting the delay time to
turn off the light when the PIR motion is not detected
Value
4 — 127 8 seconds per tick, and minimum time is 32 seconds, default tick is 4 (32 seconds) (Default 4)
Auto Report Battery Time (Parameter Number 10, Parameter Size 1) interval time for auto report the battery
level
Value
1 — 127 30 minutes per tick and minimum time is 30 minutes, default tick is 12 (6 hours) (Default 12)
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 6
Description
Description
Description
Description
Description