Behavior Within The Z-Wave Network - Philio Z-Wave PHI PSM02 Quick Start Manual

Open the casing and dissemble the front part of the case.
Put the included CR123A battery into the battery compartment and close the casing.
The sensor consists of two parts; a Detector and a Magnet. They are designed to be fitted to doors or
windows with the Magnet mounted on the opening part and the Detector mounted on the fixed frame. If
used for motion detection mount the device at a wall at about 2 m above surface. To enhance operation
place the device on a position which can detect the room widely. Mount the device with the included screws
or the adhesive tape on a plane surface.

Behavior within the Z-Wave network

I On factory default the device does not belong to any Z-Wave network. The device needs to join an
existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the
primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion
mode. Please refer to your primary controllers manual on how to turn your controller into inclusion or
exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave
the network. Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network.
Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to
be reset first.
Tripple Click the Temper Switch on the backside confirms inclusion and exclusion.
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 3