Troubleshooting - AEG 47132MM-MN User Manual

24 www.aeg.com
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.

12. TROUBLESHOOTING

12.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
The burners do not work.
There is no spark when you
try to activate the spark gen-
erator.
The flame extinguishes im-
mediately after ignition.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp. The
lamp and the lamp glass
cover can be hot.
The lamp glass cover is at
the back of the cavity.
WARNING!
Refer to Safety chapters.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is released.
There is no gas supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated
up sufficiently.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Check the gas connection.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.