Removing The Oven Door - AEG 49176V-MN User Manual

WARNING!
Keep children away when
you clean the oven at a high
temperature. The oven
surface becomes very hot
and there is a risk of burns.
CAUTION!
Always turn the oven light on
while using the catalytic
cleaning (if applicable).
Before activating the
catalytic cleaning remove all
the accessories from the
oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects
on the walls while the appliance
operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1. Clean the oven floor with warm water
and washing up liquid, then dry it.
2. Set the function.
3. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
4. When the appliance is cool, clean it
with a soft and moist sponge.
11.4 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the shelf supports in the opposite
sequence.
CAUTION!
Make sure that the longer
fixing wire is in the front. The
ends of the two wires must
point to the rear. Incorrect
installation can cause
damage to the enamel.

11.5 Removing the oven door -

top oven
To make the cleaning easier, remove the
door.
1. Open the oven door about one-third
of the way.
2. Hold the sides of the oven door with
both hands and pull the door off the
oven.
CAUTION!
Put the oven door with the
outer side down on a soft
material and level surface to
prevent from scratches.
ENGLISH 31
2
30°