Fingerprint Reader Board - HP ENVY Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board
Fingerprint reader bracket
Fingerprint reader cable
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
7. Remove the right speaker
Remove the fingerprint reader board:
1. Disconnect the fingerprint reader board cable (1) from the touchpad board.
2. Pull the ribbon cable up to disengage the adhesive securing it to the computer (2).
3. Remove the Phillips broadhead PM2.0×5.0 screw (3) that secures the fingerprint reader board to the
computer.
4. Lift the bracket from atop the fingerprint reader board (4).
5. Remove the fingerprint reader board (5) from the computer while routing the fingerprint reader board
cable under the cables.
Reverse this procedure to install the fingerprint reader board.
Bottom cover on page
Battery on page 48).
Hard drive on page 49).
(Speakers (front) on page
31).
51).
Component replacement procedures
Spare part number
818089-001
812700-001
818039-001
55