Speaker (Rear) - HP ENVY Maintenance And Service Manual

Speaker (rear)

Description
Speaker Kit
Before removing the rear speaker, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
7. Remove the system board (see
Remove the rear speaker:
1. Remove the broadhead Phillips PM2.0×2.0 screw (1) that secures the speaker to the computer.
NOTE:
performance of the speaker.
2. Remove the rear speaker (3).
Reverse this procedure to install the rear speaker.
Bottom cover on page
Battery on page
Hard drive on page
System board on page
The speaker includes rubber isolators (2) around the screws. These isolators are crucial to the
31).
48).
49).
59).
Component replacement procedures
Spare part number
812705-001
63