Noise Generated Under Motor Cover - Vision Fitness Vision series Service Manual

Noises generated under motor cover
Possible causes:
1. The running belt tension is adjusted too tight.
2. The bearing of front roller is not installed correctly.
3. Dirty grooves of drive belt.
4. The motor is damaged.
Fix:
2. Replace the front roller with a new one to see if the noise disappear.
3. Remove drive-belt and check the grooves in belt for dirt or dust and clean if
necessary. Clean also the motor pulley and the roller pulley grooves and check
if the noise has disappeared.
4. The motor bearing is damaged.
(Refer to "motor bearings replacement procedure" ... ... page 7-15)
u Replace the motor.
1. Adjust the belt tension so
that the belt does not start
slipping and then check if the
noise has disappeared.
u Let the treadmill run,
without using it, for at least 5
days because sometimes the
bearing will settle and become
quiet then check if the noise
has disappeared.
6-4 Revision: 1.0 Date: 2001-06-01