Configuring A Printer (Mac) - SAGEMCOM F@st 5260 User Manual

Sagemcom F@st 5260
If the printer was previously installed on this PC, then
the driver should appear in the list under the proper
manufacturer and printer name.
NOTE:
Check the bottom of the list for your manufacturer.
Printers are not always listed alphabetically.
If your driver does not appear, you will need to locate
the correct driver and click Have Disk to install it.
6. (Optional). You can choose to set this printer as your
system Default Printer by selecting the checkbox next
to "Set as default printer". Click Next.
7. If everything is configured correctly, the Wizard will
display the message, "You have successfully
completed the Add Printer Wizard." Installation can be
verified using the "Print Test Page" button. Click Finish
to complete.

Configuring a Printer (MAC)

1. In the "Print & Fax" dialog, click + to add a printer.
2. Click the IP tab.

Change the protocol to IPP.

Set address to http://192.168.1.1:631/IPP

Set Queue name to (blank).

Under Print Using, choose "Select a device
driver to use".
Chapter 3: USB Sharing
26