Install Your Wireless Router - SAGEMCOM F@st 5260 User Manual

Sagemcom F@st 5260

Install your Wireless Router

NOTE:
If there is an Ethernet cable currently connecting your
modem to another device, disconnect the Ethernet
cable from the device before you install your router.
1. Unplug your modem.
2. Re-plug your modem. Wait approximately 2 minutes
until your modem turns on.
3. Connect one end of the Ethernet cable to your modem.
Connect the other end to the yellow Internet port on
your router.
4. Connect the power adapter to the power input of your
router, then plug it in. Press the power switch.
Chapter 2: Getting Started
5. The router is ready to use when the following indicator
lights are solid green:
6. After installing the hardware, you can now connect to
the Internet.
a. On your device (PC, laptop, phone, tablet, etc.)
open the software utility that manages WiFi
connections.
b. Find the Network Name (SSID) as listed on the
label of your router.
When searching on your device, 2 network names
that may appear:

MyCharterWiFixx-2G

MyCharterWiFixx-5G
(where xx is specific to your router)
If you see the name ending in '5G', your device is
5GHz-capable. Connecting to the '5G' network
may provide a better experience.
c. Enter the password listed on the label of your
router. You should now be connected to the
Internet.
NOTE:
9