Enabling Wps Push Button Pairing; Change Your Time Zone - SAGEMCOM F@st 5260 User Manual

Sagemcom F@st 5260

Enabling WPS Push Button pairing

WPS (WiFi Protected Setup) push button pairing provides an
easy way to join devices to your WiFi network with the push of
a button. By default, WPS is disabled. To enable it, follow the
instructions below:
1. Log in to the Web GUI.
2. Select the network you wish to configure. You should
enable WPS on both WiFi networks to easily pair
devices to either network using the WPS button.
3. In the General Tab, under the Security section, click on
Advanced.
4. Slide the Enable WPS switch to On.
5. Under WPS Mode, leave the selection to the Push
Button default.
6. Click Ok.
7. Prior to adding a device, you may now press the WPS
button located on the side panel of your router to
enable easy pairing. Press and hold the WPS button
for 5 seconds until WPS light flashes to enable WPS
push-button pairing mode. If your device supports WPS
pairing, it should connect as soon as you select the
WiFi network name.

Change your time zone

You may wish to change your time zone to ensure that times
for parental controls are administered accurately. The default
time zone is Central time with automatic adjustment for
daylight savings time enabled.
Chapter 2: Getting Started
15