Code Of Practice; Directions For Maintenance Of The Engine Management System (Ems) - PGO Tigra AF-125BAE Service Manual

1-4 Code of practice:

1. Any clamp or cotter pin removed shall be replaced with a new one.
2. Any part to be replaced shall be manufactured by Motive Power.
3. Make sure of any assembled component securely fastened and formally activated.
4. Any bolts or nuts with large external diameters rather than small ones shall be screwed first and
diagonally according to rated torque values as follows.
5. Any mechanic shall use specific or common tools for any disassembly and wear work shoes during
maintenance.
6. The safety of any maintenance operation practiced by two mechanics shall be ensured each other.
7. Any electrical parts slightly heated with the motorcycle started are normal and not touched by hands
directly.
8. Please keep any cable or wire harness to be installed properly fixed but not excessively tensioned or
loosened without any acute (or sharp) angle or bulged bolt (or screw) piercing a cable. Check any
cable or wire harness installed for any unnecessary twist or kink.
9. Do not put any tool on the motorcycle, particularly the battery unit to become a short circuit, during
maintenance.
10. The battery in a motorcycle which has not been started for a long period shall be tested once to ensure
its voltages and charged per month.
11. Please follow the correct steps to connect and disconnect a lead acid battery without the short circuit
or inflammation.

1-4-1 Directions for maintenance of the Engine Management System (EMS)

1) Directions for General Maintenance
Any check to the Electronic Management System shall be made with a multi-meter only.
1. To make sure of the Electronic Management System properly running, please use parts supplied by
Motive Power during maintenance.
2. Any operation to clean parts during maintenance shall be executed in a well-ventilated place.
3. Please follow the directions for steps of maintenance and diagnosis.
4. Do not disassemble or remove parts in the Electronic Management System during maintenance.
5. Please keep watch for any electronic element (electronic control unit, sensor, etc.) not fallen to the
ground during maintenance; establish the environmental protection concept for any waste from
maintenance invalidly disposed.
2) Directions during maintenance
1. Do not arbitrarily remove any part or connector of the Electronic Management System from its
initial position; avoid any accidental damage or foreign object such as water and greasy dirt to
enter into any connector and affect a properly running Electronic Management System.
2. In order to prevent any electrical device from damage, the power supply shall be disconnected
Information Summary and Preparation 1
6