Turn Power On - Sony SR-R1 Operation Manual

Turn Power On

To power up the unit
1
When using the AC adapter, turn
power to the AC adapter on.
2
Press the power switch on the SR-R1 on
the ? side.
Power comes on and the POWER indicator
lights up in green.
To power down the unit
1
Press the power switch on the SR-R1 on
the 1 side.
Power is turned off and the POWER
indicator goes out.
2
When using the AC adapter, turn
power to the AC adapter off.
Note
To prevent the risk of data corruption, do not interrupt
the DC IN power supply while the SR-R1 is turned on.
Tip
If power is turned off while an SRMemory card is
mounted, the unit will not power down immediately, to
protect the data on the card. The SRMemory card will be
unmounted first, and then the unit powers down.
Checking the power/voltage
The indication at the bottom left of the control
panel display serves to verify the battery status or
the voltage of the external power supply.
However, this indication is not based on the
actual connection condition but on the setting
made under SYSTEM Setup > BATTERY >
DCIN TYPE. (see page 83)
Set DCIN TYPE to match the power supply being
used.
Tips
• When signal format and SR Motion are shown, the
indication appears at bottom right. (see page 14)
22 Turn Power On
• The voltage shown is the actual voltage used by the
unit (this may be lower than the input voltage and the
DC IN connector).
When a battery pack is selected
The battery symbol is shown.
16.5V
• When fully charged, all seven segments are lit.
As the battery pack discharges, the segments go
out from left to right.
• When the battery pack is almost exhausted
(NEAR END), the voltage indication and the
tally indicator start to flash, and an intermittent
warning tone sounds in the earphones.
• When the battery pack is completely exhausted
(END), the corresponding warning indication
lights, the tally indicator starts to flash at a
higher rate, and the earphones warning tone
sounds continuously.
Tip
The DCIN TYPE option in the SYSTEM Setup menu
allows you to set the battery voltages which trigger the
NEAR END and END warnings. (see page 83)
When AC power is selected
The connector symbol is shown.
16.5V