Warning System - Sony SR-R1 Operation Manual

Warning System

When an error is detected immediately after the system is powered on, or during operation, the display
and the tally indicator (see page 10) provide a warning indication.
In addition, warning and alarm tones are output from the EARPHONES jack.
Note
Warning tones are only output if the BEEP (PHONE) > WARN (see page 76) setting in the AUDIO Setup menu is HIGH
or LOW.
Warning tones Alarm tones
:
1 beeps/second 1 beeps/second
:
4 beeps/second 4 beeps/second
:
Continuous tone Continuous tone
— —
a)
—
—
—
—
—
—
a) Output only during recording.
b) Flashes during recording.
c) You can use the battery level/external power indication on the display to check the state of the battery. (see page 14, 22)
Tally indicator Description
:
:
1 flashes/
second
:
:
4 flashes/
:
second
— An error as
indicated by
warning message
has occurred.
(Excluding "Servo
lock lost during
recording" below)
b)
Servo lock lost
during recording
An error occurred. Operation
a)
SRMemory card is
almost full.
SRMemory card is
full.
a)
Battery is almost
empty.
Battery is empty.
SR-R1
operation
Operation
continues.
Recording
continues, but
results may
invalid.
continues or
stops,
depending on
the type of
error.
Operation
continues.
Recording,
playback, or
search
forward stops.
Operation
c)
continues.
c)
Operation
stops.
Countermeasures
Check the warning
message, and resolve
the condition, referring
to the "Description"
column in "Warning
messages" (page 89).
Check the input signal.
Check the error
message, and resolve
the condition, referring
to the "Description"
column in "Warning
messages" (page 89).
Alternatively, contact a
Sony service
representative.
Prepare to replace
SRMemory card.
Replace SRMemory
Card or delete
unneeded files.
Replace battery.
Replace battery.
Warning System 91