Sony SR-R1 Operation Manual page 79

Setting Item
SIGNAL FORMAT SELECT FPS
Settings of signal
formats
FPS FORMAT
ENCODE
HD SDI
SDI OUT
TEST SG VIDEO
Settings of test signal
output
Note
The VIDEO and
AUDIO settings are
both reset to "OFF"
AUDIO
(factory default
setting) when the
power is turned off.
Settings
Selects the operation mode of the Select FPS function.
OFF [Off]: Does not use the Select FPS function.
ON [On]: Enables the Select FPS function and sets the
number of frames (FPS) on the camera side.
RECORDER [RECORDER]: Enables the Select FPS
function and sets the number of frames (FPS) on the
unit.
For details on the settings, see "SR Motion" (page 47).
Selects the system format for when Select FPS operation.
DEF [Default]: Uses the factory default setting.
23/24 [23.98/24]
25 [25]
29/30 [29.97/30]
50 [50]
59/60 [59.94/60]
For details on the settings, see "SR Motion" (page 47).
Sets the video recording format and recording rate.
SR-HQ 12bit, SR-HQ 10bit, SR-SQ, SR-Lite, DPX
For details, see "About Recording/Playback Formats"
(page 97).
Sets the HD SDI IN connectors A/B.
1.5G: 1.5G SDI
3G: 3G SDI
Sets the HD SDI OUT (MON) connectors 1/2.
1.5G: 1.5G SDI
3G: 3G SDI
Selects the test signal to generate with the internal video
signal generator.
OFF [Off]: Does not generate a test signal.
CB [Color Bar]: Color bar signal
SMPTE [SMPTE Color Bar]: SMPTE color bar signal
RP219 [RP-219 Color Bar]: RP-219 color bar signal
BLK [Black]: Black signal
Selects the test signal to generate with the internal audio
signal generator.
OFF [Off]: Does not generate a test signal.
1KHz [1KHz Sine]: 1 kHz sine wave
NONE [Silence]: No sound
SYSTEM Setup Menu 79