Sony SR-R1 Operation Manual page 83

Setting Item
POWER SDI OUT
Settings to reduce
power consumption
by limiting output
signals or restricting
LED
use of output
connectors
TALLY
STBY OFF
BATTERY DCIN TYPE
Settings related to the
remaining battery
power indication
SETUP COMMENT
For details, see
SAVE
"Storing and
LOAD
Recalling Setup
RESET
Data" (page 29).
Settings
Selects whether to output signals from the HD SDI OUT
connectors A/B.
ON [On]: Outputs signals.
OFF [Off]: Does not output signals.
Controls the POWER indicator.
ON [On]: Lit normally
LOW [Low]: Dimly lit
OFF [Off]: Not lit
Controls the tally lamp.
ON [On]: Lit normally
LOW [Low]: Dimly lit
OFF [Off]: Not lit
Sets the time to transfer from playback stop mode to
standby off mode.
1sec [1sec]: After 1 second
5sec [5sec]: After 5 seconds
10sec [10sec]: After 10 seconds
20sec [20sec]: After 20 seconds
30sec [30sec]: After 30 seconds
40sec [40sec]: After 40 seconds
50sec [50sec]: After 50 seconds
1min [1min]: After 1 minute
2min [2min]: After 2 minutes
3min [3min]: After 3 minutes
4min [4min]: After 4 minutes
5min [5min]: After 5 minutes
6min [6min]: After 6 minutes
7min [7min]: After 7 minutes
8min [8min]: After 8 minutes
30min [30min]: After 30 minutes
Selects the type of battery to be connected to the DC IN
connector.
AC [AC Adapter]: AC adapter
Li-ion [Li-ion Battery]: Lithium ion battery
BP-GL [BP-GL Battery]: BP-GL95
OTH1 [Other 1]
OTH2 [Other 2]
Near END Sets the threshold voltage at which to show a near-end
(DCIN) (almost exhausted)/warning indication for the battery
selected for the previous item "DCIN TYPE."
11.0 to 15.0 (11.9 V)
END (DCIN) Sets the threshold voltage at which to show an end
(exhausted)/warning indication for the battery selected for
the item "DCIN TYPE."
11.0 to 12.0 (11.0 V)
Edits comments when saving the setup menu.
Saves setup information to a "Memory Stick."
Loads setup information from a "Memory Stick."
Restores the setup information to the factory default
settings.
SYSTEM Setup Menu 83