About Warning Messages - Sony SR-R1 Operation Manual

Code Message Meaning
0071 UNMOUNT An error was generated in
ERROR2 the memory section when
unmounting/ejecting the
SRMemory card.
The ejected SRMemory
card may not be able to be
used.
The salvage function may
need to be executed.
0074 MOUNT An error was generated in
ERROR1 the interface section when
mounting the SRMemory
card.
This SRMemory card
cannot be used as is.
Execute the salvage
function or use another
SRMemory card.
0075 MOUNT An error was generated in
ERROR2 the memory section when
mounting the SRMemory
card.
This SRMemory card
cannot be used as is.
Execute the salvage
function or use another
SRMemory card.

About Warning Messages

If one of the conditions described in the
"Warning messages" (page 89) is detected, a
warning message code appears in the operation
status and warnings section of the HOME screen
(see page 13).
To check the content of warning messages
Press the SELECT/ENTER dial on the control
panel. A popup window appears to display
messages for the current warnings.
Tip
Only one message is displayed at one time, even if
multiple errors and warnings occur. The number of
current errors and warnings appears at the bottom of the
popup window. Be sure to check the messages for all
errors and warnings.
Example:
Popup window displaying warning message
"0007: REC INHIBIT MODE" (recording inhibit
mode)
dB
SDI SDI SDI SDI SDI SDI SDI SDI
0
-10
WARNING
-20
-30
-60
EMP EMP EMP EMP EMP EMP EMP EMP
EE
L R L R L R L R L R L R L R L R
1 2 3 4 5 6 7 8
0007 0007
REC INHIBIT MODE REC INHIBIT MODE
PLAY LOCK
TCR LTC INTRP DF
Rec Inhibit Mode
00 00 00
H M
O Error(s)/
16.5V REMAIN
ENCODE
SR-SQ
10min
12bit
Indicates that there are no current
error messages (see page 88).
Indicates that there are three
current warnings.
To view the other messages, rotate the
SELECT/ENTER dial on the control panel.
When a warning message appears
Take any action that may be needed to eliminate
the cause of the warning.
Warning messages
Code Message Meaning
0007 REC INHIBIT Recording is not possible
MODE due to a menu setting. Or
the recording format is not
supported.
0009 TEMPERATURE The internal temperature
LOW of the set is lower than the
specified level.
000C CP MISSING Communication with the
control panel was
interrupted.
000E TEMPERATUR The internal temperature
E HIGH of the set has risen.
0030 NO SDI There is no valid input to
INPUT the HD SDI IN connector.
0032 INVALID SDI The SDI input signal data
DATA is invalid.
0034 SDI A-B Signals input to HD SDI
PHASE NG IN A and B connectors are
out of phase.
Error Messages and Warning Messages
SDI SDI SDI SDI SDI SDI SDI SDI
EMP EMP EMP EMP EMP EMP EMP EMP
L R L R L R L R L R L R L R L R
9 10 11 12 13 14 15 16
VTR OOOOO
EXT-LK KEYINHI
RECINHI
00
S F
3 Warning(s)
IN: --:--:--:--
LOCAL
1920x1080
EE
M
59.94I
21:46
4:2:2
89