Polishing (Without Vacuuming) - Kärcher BR 45/40 Service Manual

6.8.5 Polishing (without vacuuming)

Initial use
Shutting down
Switch the programme selector switch (S2) to position "Polish"

Drive switch (S4) switched off

Cleanspeed active ("Cleanspeed Edit" set to "1" in setup menu)
Display
Battery: E...F

Red LED "Fault" is glowing continuous-
ly

After approx. 10 seconds of overload,
the following will be shut off
Brush motor
–
Solenoid valve water
–
Dosing pump detergent (optional)
–

Display
Brush overload

Red LED "Fault" is blinking

Switch the key switch off and perform
startup
Display
Battery: E...F
Yes
Continued on next page.
Drive and brush motor
(M1 und M2) ready
Deadman switch (S3)
actuated?
Yes
Brush motor (M1) active
Brush motor overload?
No
Drive switch (S4)
switched on?
Yes
The drive motor (M3)
starts via the on ramp
and moves forward con-
tinuously at 4 km/h.
English 5.906-269.0 Rev. 00 (03/11)
No
No
51