Polishing (Without Vacuuming) - Kärcher BR 45/40 Service Manual

6.8.3 Polishing (without vacuuming)

Initial use
Shutting down
Switch the programme selector switch (S2) to position "wet scrubbing without vacuuming"

Drive switch (S4) switched off

Cleanspeed active ("Cleanspeed Edit" set to "1" in setup menu)

Suction turbine speed (M2) ("SUCTred Edit" set to "1" in setup menu)

DOSE active, ("DOSE Edit" set to "1" in setup menu) (option)
Display
Battery: E...F

Red LED "Fault" is glowing continuous-
ly

After approx. 10 seconds of overload,
the following will be shut off
Brush motor
–
Solenoid valve water
–
Dosing pump detergent (optional)
–

Display
Brush overload

Red LED "Fault" is blinking

Switch the key switch off and perform
startup
Continued on next page.
Display
Battery: E...F
Drive and brush motor
(M1 und M2) ready
Deadman switch (S3)
actuated?
Brush motor (M1) active
- Check the solenoid
valve.
Yes Brush motor overload?
(Option) switch for deter-
gent (S5) on?
Dosing pump (optional)
on
No
Yes
No
No
Yes
English 5.906-269.0 Rev. 00 (03/11)
47