Hitachi WH 18DSDL Safety Instructions And Instruction Manual page 11

English
m_
I
I
APPLICATIONS
<WH18DSDL>
Driving and removing of machine screws, wood
screws,tapping screws,etc.
<WR18DSDL>
Tightening and loosening of all types of bolts and
nuts, usedfor securingstructural items
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 3).
/_ CAUTION
Never short-circuit thebattery.
2. Battery installation
Insert the batterywhile observing its polarities (see
Fig.3).
Pull out
l_ Handle
Insert ))-_-'-q'N_
,'" _ Latch
"" Push
Battery
Fig.3
CHARGING METHOD
NOTE:
Before plugging into the receptacle,makesure the
following points.
O The power source voltage is stated on the
nameplate.
© The cord is not damaged.
/k
WARNING:
Donotchargeat voltagehigherthanindicated on
the nameplate.
If charged at voltagehigherthan indicated onthe
nameplate, t he chargerwill burnout.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-secondintervals)
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insertthe battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig.4, 5.
Battery
Pilot ,amp ___
Charger
Fig.4
Line
Fig.5
3. Charging
Whenthe batteryisconnectedto the batterycharger,
chargingwill commenceandthe pilot lampwill light
in red. (SeeTable 2)
NOTE:
Ifthe pilot lamp flikers in red, pull out the plug from
the receptacle and check if the battery is properly
mounted.
When the batteryisfully charged,the pilot lampwill
blinkin redslowly. (At 1-second intervals)(SeeTable
2)
11
O1Eng WH18DSDL US.p65 11 10/2/12, 2:38 PM