Mastercook KGE-3440ZB Plus Instruction Manual page 53

Problem
While igniting one of the burners all the
hob burner igniters spark
Parts made of stainless steel (inox) deve-
lop stains that cannot be removed with the
use of standard cleaners
Smoke coming out of the oven
Oven light does not function
"0.00" pulsates on the display
Damaged power lead
Cooking results are not what you expec-
ted
NOTE !
If after completing the above steps the appliance is still inoperative contact your local service cen-
tre.
It is normal
When pressing the selected knob (with a built-in ignition device) or the
ignition button sparks are re-leased at all the burners .
– Stainless steel surfaces should be cleaned
and only with the use of special stainless steel cleaner.
– Open the windows to air the kitchen,
– When the oven cools down, clean its interior and especially the spit.
– Use the drip tray when grilling foods.
1. Check to make sure the cooker is connected to the electrical mains.
2. The bulb is burnt or not screwed all the way in.
Disconnect the cooker from the electrical mains before fixing the
fault.
– Unscrew glass bowl 1 from light socket 2 and screw bulb 3 all the
way in or replace the bulb with a new one (bulb type: E14 230V 25W,
resistant to temperature of 300
Drop or temporary breakdown of voltage. Take the plug out of the electric
socket, wait for a while, then plug in the cord and set the current time.
In order to avoid hazards, damaged power lead should be exchanged
at the manufacturer's or by a specialist servicing point, or by a qualified
person.
The cooking parameters given in the instruction manual should be tre-
ated as guidance only. In practice, these parameters are dependable on
the weight and consistency of food, cooking tray level, etc. Therefore, we
recommend making a few trials for your favourite foods and then writing
down the optimal time and temperature.
52
Solution
each time they get soiled
0 C).
EN