Troubleshooting - Mastercook KGE-3440ZB Plus Instruction Manual

EN
– grasp the door with both hands, turn it by about
0
45 (in the closing direction) and pull the hinges
out of their seats (fig. 13.4.3).
NOTE !
1. As the hinge's bow is very tight, remove the
doors carefully to avoid hurting your fingers.
2. It is forbidden to clean the oven with the use of
steam pressure cleaners.
If the light bowl is dirty, unscrew the bowl, and wash
and dry it thoroughly (13.4.4).
• Enamelled ovens are coated with ceramic ena-
mel.
• For enamel surfaces use kitchen-cleaning agents.
• For removing difficult baking stains, special oven
cleaning agents are recommended. However, the-
se agents are caustic and therefore should be used
in small quantities and with utmost care. Please
follow the manufacturer's instructions carefully.
Problem
Igniters fail to ignite or not always ignite
the gas
14.1.1
Gas burners fail to ignite
Flame dies after releasing the knob
After setting the knob to simmering flame
position - the flame dies or is too high
Flame is unstable
– Check to make sure the cooker is connected to the electrical mains.
– Clean and dry the igniters and burner components.
– Check to make sure the burner caps and heads are placed correctly.
– Press on the burner cap and rub it against the head by turning right
and left (fig. 14.1.1).
– Rub the igniter electrode with the use of hard brush or smooth file (fig.
14.1.2).
14.1.2
– Check to make sure the rubber hose supplying gas from the gas cylin-
der is not squeezed.
– Check to make sure the gas main valve is open.
– Check to make sure the gas cylinder is not empty.
– In case a new cooker has been installed or the gas cylinder has been
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
– Check to make sure the nozzle or burner flame holes are not clogged
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo-
nents.
Your cooker is equipped with a flame failure safety device
– Where the ignition device is built in the knob set the
me
all the way in for another few seconds. .
– Avoid draughts in the kitchen,
– Call the fitter to adjust simmering flame position
– Check to make sure that the burner components are clean, dry and
placed correctly.
NOTE !
Before proceeding with the troubleshooting, di-
sconnect the cooker from the power supply to
avoid being electrocuted.
• In the warranty period all repairs except for the
ones specified below should be carried out by the
authorised Servicing Point.
• If there are some disturbances during the use of
the appliance, follow the guidelines below to check
if you can repair the defect yourself.
Solution
, press the knob and when the gas has ignited keep it pressed
51
knob to large fla-
.