Direct Address Program Mode; Direct Address Overview; Address Mode Displays; Binary (Bit) Format Example - NAPCO Gemini GEM-P816 Programming Instructions Manual

DIRECT ADDRESS PROGRAM MODE

DIRECT ADDRESS OVERVIEW

Direct Address Programming allows you to go directly to the address locations (up to 2287) and change the data entries
manually in order to customize your control panel options. Whereas the Easy Menu Program Mode guides you through
limited selections to get you started, Direct Address Program Mode allows you to change all options directly. It con-
sists of up to 2287 address locations each with data entry locations as shown in the following diagram (below left). The
data entry location accepts data in one of three formats: Binary, Decimal and Hexadecimal (explained below in
"Address Mode Displays"). The following diagram (below right) illustrates a Decimal format data entry location (using
a GEM-RP1CAe2 keypad).
ADDRESS
LOCATIONS
0000
0000
TO
2287

ADDRESS MODE DISPLAYS

There are three types of address displays when programming in Direct Entry Program Mode, as follows:
A) Binary (Bit) Format Example
Settings (such as Zone Features) display and accept data in "number" format. For example, Zone Features are
turned on by the pressing of keypad buttons 1 through 8, with the activated Zone(s) displaying the corresponding
decimal digit (replacing deactivated zones which are signified by dashes).
EXAMPLE: BIT Format with the GEM-RP1CAe2: Program Zones 2, 4, 5 and 7 as Exit/Entry Follower Zones.
0916 - - - - - - - -
Address
DATA ENTRY LOCATION:
0916
"Exit/Entry
•
No zones yet activated
Follower"
DETERMINE THE DATA ENTRIES
1. Referring to ZONE FEATURES in the Programming Worksheets that follow, the Exit/Entry Follower for Zones 1
through 8 are located at address 0916.
NAPCO Security Systems
R
DATA ENTRY
LOCATION
DATA ENTRY LOCATION:
(One of three formats):
•
Binary (Bit)
•
Decimal
•
Hexadecimal
B
Binary (Bit) Format
GEM-RP1CAe2 Keypad Display Example
1
0 0 0 0 0 6 0
1
= ADDRESS LOCATION
2
= DATA ENTRY LOCATION
0916 - 2 - 4 5 - 7 -
Address
0916
"Exit/Entry
Press
2 4 5
Follower"
vate Zones 2, 4, 5, and 7. (The "B" on the right indi-
cates "Binary" format).
range from 0-7, these "option numbers" 2,4,5 and 7
correspond to "bit numbers" 1,3,4 and 6, respec-
tively.
GEM-P816 Programming Instructions
2
B
DATA ENTRY LOCATION:
Binary (Bit) Format
and in order to acti-
7
Because "bit numbers"
Page 11
D