NAPCO Gemini GEM-P816 Programming Instructions Manual page 41

New
Compat #
EZM Address
designate the keypad as Group "01" at the "
group number "01" through "14". (Each EZM must have a unique assigned group number, starting with "01" and pro-
ceeding consecutively.) Press the
Zone Response
3. At the keypad, enter the sum as a two-digit number "01" through "15" on the display, then press
Example. Change Zones 2, 3 and 4 to 50mS response.
1. Circle numbers for Zones 2, 3 and 4: (2), (4) and (8).
2. Add up the circled numbers: 2 + 4 + 8 = 14.
3. Enter "14" at the keypad, then press the
Press the button to continue or press the
R
Program Control
Message #
tion Mode (display will read "
NAPCO Security Systems
R
Compatibility Number (Not Applicable)
THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P816 CONTROL
PANEL. DO NOT CHANGE THIS SETTING.
0000
Press the
R
EZM Address
The keypad's internal EZM (Expansion Zone Module) may be utilized to
provide four additional wired zones. Whether used alone or in conjunction
01
with optional GEM-EZM series modules or other keypad EZMs, it must be
assigned a unique address (or Group number, see Keypad Programming
Workbook) similar to its keypad address. If no other EZMs are to be used,
EZM ADDRESS 00
button to continue or press the
R
Zone Response
The normal loop response of each keypad expansion zone is 750mS, how-
ever the response time of any zone can be reduced to 50mS as follows.
00
1. Of the following, circle the number(s) in parentheses associated with the
zone(s) to be changed: Zone 1=(1); Zone 2=(2); Zone 3=(4); Zone 4=(8)
2. Add up the circled numbers.
U
button.
C
Program Control Message (Not Applicable)
THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P816 CONTROL
PANEL.
?
Press the
tions, for changes) or press the
"). Then replace Jumper JP1 across Pins 1–2 (top two).
01 OUT OF SYSTEM
button to continue or press the
" display. In multiple-EZM systems, enter an assigned
C
button to exit.
button to continue (the display will loop back through selec-
R
C
GEM-P816 Programming Instructions
button to exit.
C
button to exit.
U
.
button to exit the Keypad Configura-
Page 41