Accessing User Program Mode; User Codes - NAPCO Gemini GEM-P816 Programming Instructions Manual

Page 38

ACCESSING USER PROGRAM MODE

1. Press EEEEEE
2. Press Q
3. Press P
4. Press C

USER CODES

Enter user code
U01 123
GEM-K1CAe2 Keypad (Direct Entry)
Up to 16 User Codes may be programmed.
NOTE: In this mode, only the code is pro-
grammable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 5).
Use the button to place the cursor
R
over the User Number.
Enter a User Number (01–16) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
G 0
U
Press the button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT/YES button or the
PRIOR/NO button.
GEM-P816 Programming Instructions
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
Until "ACTIVATE PROGRAM Y/N" appears on LCD screen.
To Enter User Program Mode
To Exit User Program Mode when finished
- 9-
To Program User Codes
1. Set Cursor Position using the
R
2. Enter 2-digit User Number (01-
16) directly using number but-
tons (0-9).
3. Enter Code (1-6 digits) directly
using number buttons (0-9).
4. Press the
each code.
NOTE: Press
button.
G E M I N I
button.
U
button to save
G 0 button to clear character at cursor.
To continue press P or Q button.
Programming User Codes with GEM-K1CA Keypad
R
User Code
E n t e r u s e r c o d e
U 0 1 1 2 3 - -
R 1 2 3
B 4 5 6
C 7 8 9 0
C O M P U T E R I Z E D S E C U R I T Y S Y S T E M
NAPCO Security Systems
R
NOT USED
NEXT/YES
U
P
PRIOR/NO
Q
AREA
G