Fuel Alarm; Temperature Alarm; Cut Off The Oil And Power System; Resume The Oil And Power System - Coban GPS106A User Manual

Gsm/gprs/gps vehicle tracker
Table of Contents

Advertisement

80km/h, the tracker will send SMS "speed+080!+latitude/longitude" to the authorized
numbers in 3 minutes interval.
Cancel: Send SMS "nospeed+password" to deactivate the overspeed alarm.
Remark: The recommended speed should be not less than 30km/h. For below that rate, it
will be effected the accuracy by GPS signals drift etc.

6.17.7 Fuel alarm

If the tracker device detects the fuel decrease by 8% in three minutes, then it will
send oil leak or theft alarm "oil: xx%+latitude/longitude" to authorized numbers in 3
minutes interval. Siren beeps 30 seconds.
Cancel fuel alarm: Send SMS command "nooil+password" to tracker.

6.17.8 Temperature alarm

6.17.8.1 Send SMS command"temperature+password+space+***C, ***C"to the
tracker,it will reply "temperature ok" .When the temperature is beyond the
limited range, the tracker will send SMS alarm to the authorized numbers in 3
minutes interval.
For example: Send SMS "temperature123456 -020C,060C" ,when the
temperature is below -20℃ or above 60℃,the tracker will send SMS alarm to
the authorized numbers in 3 minutes interval.
6.17.8.2 Cancel temperature alarm: Send SMS command "notemperature+password"
to tracker,it will reply "notemperature OK"
6.17.8.3 Switch between Celsius and Fahrenheit
The default temperature unit is Celsius,send SMS command"temperature+password
+space***F, ***F" to the device,it will reply "temperature ok",then the
temperature unit has switched to Fahrenheit
6.17.8.4 Notes: The available temperature range is from-040℃to +500℃,the
number should be 3 digits and temperature unit must be in upper case in SMS
command

6.18 Cut off the Oil and Power System

Send SMS command "stop+password" to the tracker device, it will reply "Stop engine
Succeed" to your cell phone from the tracker device, and stop your car engine. At the same
time, it will remain the immobile state until receiving the next SMS command of resuming
the oil and power once receiving SMS command to cut off the oil and power system

6.19 Resume the Oil and Power System

Send SMS command "resume+password" to the unit, It will reply "Resume engine
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gps106b

Table of Contents