Coban GPS106A User Manual page 7

6.1.1 Please ask the qualified engineers to install.
6.1.2 Do not install it in an environment which is over GSM performance and please pay
attention to fix the antennas in a position with good signals.
6.1.3 Pay attention to make installation location preventing water and dust.
6.1.4 Find the 14PIN harness and insert it into the corresponding holes of the products,
and connect the wires with the original car circuit showing below:
6.1.5 Note: The orange wire can be connected to the original car siren; it can also be
connected to the separate siren you buy with the tracker. (Siren is Option)
6.1.6 The tracker is compatible with the original vehicle anti-theft device, in order to
realize the feature, the gray line connects to the original car siren, and then the
tracker device can synchronize the alarm and disarm with the original vehicle
anti-theft device.
6.1.7 Knowing about the type of the door trigger is positive or negative. Please connect
the green wire to the door control circuit if it is positive, and connect blue wire if it is
negative.
6.1.8 Insert the shock sensor plug into the sensor port. (Shock sensor is Optional)
6.1.9 Insert the camera plug into the camera port. (Camera is optional)
6.1.10 Fuel sensor wiring: Check the wiring instructions on the communication module of
the fuel sensor. (Fuel sensor is optional)
6.1.11Insert the temperature sensor plug into the sensor port (Temperature sensor is
Optional)
6.1.12 Insert the external monitor Microphone into the monitor jack.
7
Wiring diagram