Interfaces And Communication; Rs232 And Usb Computer Interfaces; Communications Slot - AEG protect d. 1000 Operating Instructions Manual

8

Interfaces and Communication

8.1

RS232 and USB computer interfaces

There are several different interfaces available to control the UPS
and conveniently read out status messages and measurements.
The interface log is designed to be used with "CompuWatch", the
shutdown and UPS management software from AEG. Use the
RS232 or USB communication cable that comes with the device to
connect your UPS to a PC.
i
8.2

Communications slot

There is a cover on the rear panel of the UPS (see no. 12 on
Seite 31); remove it to install additional, optionally available
communication components, e.g.:
Relay card: Plug-in card with status messages, realized via
potential-free relay contacts (opener or closer)
Relay PRO card: As above, but with programmable pin
allocation, connection via terminal, additional option of remote
On/Off
SNMP card: Plug-in card for the direct integration of the UPS
into the Ethernet network via RJ45 (TCP/IP)
SNMP PRO card: As above, but with the additional option of
connecting and managing an external sensor system
For details, please refer to the descriptions that come with each
option. Additional cards are in preparation.
i
The USB and the RS232 communication interface
rule each another out, i.e. either USB or RS232.
Pin allocation of the RS232 Sub-D9 jack:
2 = TxD; 3 = RxD; 5 = GND
The communication slot can be used in parallel to
the RS232 or USB interface.
55
EN