AEG 3000D Operating And Installation Manual
Hide thumbs
Also See for 3000D:
- Operating and installation instructions (17 pages) ,
- Operating instructions manual (76 pages)
Related Manuals for AEG 3000D
Summary of Contents for AEG 3000D
- Page 1 3000 D 3010 D Dunstabzugshaube Afzuigkap Hotte aspirante Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice d’utilisation et d’installation Operating and Installation Instructions...
-
Page 2: Table Of Contents
Open the metal grease filter Charcoal filter Changing the light bulb Cleaning Special accessories Technical assistance service Guarantee conditions Technic Details Mounting accessories included Electrical connection Safety warnings for the electrician Wall unit mounting Printed on recycled paper AEG - putting words into action... -
Page 3: Safety Warnings
Safety warnings for the user • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. - Page 4 • It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities. •...
-
Page 5: Description Of The Appliance
(special accessory). • You will need original AEG charcoal filter for this function (see Special Accessories). • The air is discharged to the outside through a pipe, which must be fitted to connection flange D. -
Page 6: Hood Operation
Hood Operation • Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. -
Page 7: Led Indicator Lights For Veryfying The Saturation Of Filters
LED Indicator lights for veryfying the saturation of filters This hood is supplied without a charcoal filter. If the hood is to be used in the recirculation mode with a charcoal filter, the saturation indicator must be activated as follows: Depress and hold the B and G buttons simultaneously for 3 seconds. -
Page 8: Maintenance And Care
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. -
Page 9: Charcoal Filter
Charcoal filter • The charcoal filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG charcoal filter (see special accessories). • Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. -
Page 10: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 11: Cleaning
Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. •... -
Page 12: Guarantee Conditions
3. Should guarantee repairs be necessary the purchaser must inform the nearest customer service office (manufacturer`s service or authorised agent). AEG reserves the right to stipulate the place of the repair (i.e.the customer`s home, place of installation or AEG workshop). -
Page 13: Technic Details
Technic Details Dimensions - extractor version (in cm): Height x Width x Depht 66-112 x 89,8 x 50 Dimensions - filter version (in cm): Height x Width x Depht 75,5-122 x 89,8 x 50 Maximum absorbed power: 210 W Motor absorption: 1 x 170 W Lighting: 2 x 20W... -
Page 14: Wall Unit Mounting
Wall unit mounting - Fig. 7 First decide which functioning version is better for you. If you decide to use the hood in exhausting version we suggest to position the upper section of the chimney so that the oulet slots are not visible once installation has ended, on the contrary if is decided to use the hood in recycling version BE SURE that the side with slots is up (see also A-B- C sequence on on Fig. - Page 15 Wall unit mounting - Fig. 8 • Insert the frame, that holds controls, grease filter and lamps, in the motor housing using proper rails and fix each other with two 3x9 screws (1-2-3). • Sign the wall with a center line, this will aid mounting procedure (4), position the template so that the mid line printed on the template matches with the center line previously signed, the lower side of the template corresponds to the lower side of the hood once mounted...
- Page 16 Model 3010D Fig. 8...
- Page 19 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1M7C Ed. 07/02...