Installing The Hard Disk Drive - Cybernet iONE-GX31 Series User Manual

Installing the Hard Disk Drive

Cybernet iONE-GX31
1. Unscrew the four screws on the Optical Disk Drive
frame and remove the frame and disconnect the IDE
ribbon cable from the mainboard and set aside in
order to gain access to the Hard Disk Drive slot.
2. Slide the hard disk drive into the frame and line
up the two screw holes accordingly.
3. Secure the two screws on the Hard Disk Drive.
4. Connect the SATA cable.
5. Connect the power cable.
Replace the Optical Disk Drive securing the four
screws (two screws on the top, two screws on the
side) to secure the HDD and complete the
installation.
Page 22
System Assembly