Installing The Hard Disk Drive - Cybernet iOne-H19 Series User Manual

Installing the Hard Disk Drive

Cybernet iOne-H19
1. Unscrew the four screws on the Optical
Disk
Drive frame (2 shown circled, 2 on opposite
side) and remove the frame and
disconnect the SATA cable from the
mainboard and set aside in order to gain
access to the Hard Disk Drive slot.
Optical Disk Drive Frame Screws
2. Slide the hard disk drive into the frame and
line up the two screw holes accordingly.
Secure the two screws on the Hard Disk
Drive.
Connect the SATA cable to the mainboard.
SATA Cable
3. Connect the other end of the SATA/Power
cable to the Hard Disk Drive as shown.
4. Replace the Optical Disk Drive securing
the four screws (two screws on the top, two
screws on the side) to secure the HDD and
complete the installation.
Power Cable
Page 21
SATA Cable
Product Orientation