Setting The Channel Delay Time; Setting The Data Skip - Uniden UBC3500XLT Owner's Manual

Notes:
• If you select 0, the scanner stays on the system
for a minimal time (only long enough to check
current system activity).
• The default setting is 2 seconds for each system.
• For conventional systems, all unlocked channels
will be scanned at least once regardless of this
setting.
• The scanner moves to the next system after the
hold time expires, any current transmission ends,
and the channel delay time expires.

Setting the Channel Delay Time

Program System
Menu
Select the system
Edit Sys Option
Set Delay Time
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press E
or the scroll control.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the
system.

Setting the Data Skip

Program System
Menu
Select the system
Edit Sys Option
Set Data Skip
This setting controls how the scanner behaves when it
stops on a channel that has a data signal.
48