Wired Cloning - Uniden UBC3500XLT Owner's Manual

Wired Cloning

Wired Clone
Menu
• Master Sets the scanner to be the source scanner.
• Slave Sets the scanner to be the recipient scanner.
To clone (copy) data directly from one UBC3500XLT
scanner to another UBC3500XLT scanner, you must
first connect the scanners to each other using the
included connection cables and a DB9 null modem
adapter and DB9 gender changer (neither included),
available at most computer stores. Then you must set
one scanner as the source and the other as the
destination.
Plug the smaller end of each of the included connection
cables into Remote on the right side of each scanner.
Then connect the other end of the cables together
using the null modem connector and gender changer.
Then set the scanner containing the programming you
want to transfer as the master scanner, then set the
other scanner as the slave scanner.
(Master scanner) Clone Master Press SCAN Key
Scan
(Slave scanner) Clone Slave Press SCAN Key
Scan
When you are ready to clone the scanner, press
on the slave scanner first, then on the master scanner.
The master scanner checks the connection between the
two scanners, then transfers its data to the slave scanner.
When the transfer is complete, Complete appears on
both scanners. If the transfer did not work, Error
appears on the master scanner.
42
Scan